Show/manipulate routing, devices, policy routing and tunnels
ip -h {flag-h} 📎 flag-h ip -h {flag-h}Sandbox: execFile · Timeout: 30s
network.config.ip | Name | Type | Required | Default | Description | Aliases |
|---|---|---|---|---|---|
flag-h | file | No | - | -f[amily] { inet | inet6 | mpls | bridge | link } | -4 | -6 | -M | -B | -0 | -l[oops] { maximum-addr-flush-attempts } | -echo | -br[ief] | -o[neline] | -t[imestamp] | -ts[hort] | -b[atch] [filename... | -h, -r, -i, -j, -p |
4 | boolean | No | - | | | -4, -6, -M, -B, -0 |
c | boolean | No | - | } | -c |
f | boolean | No | - | { inet | inet6 | mpls | bridge | link } | | -f |
l | boolean | No | - | | | -l, -addr-flush-attempts, -echo, -br |
o | boolean | No | - | [filename] | | -o, -t, -ts, -b |
rc | boolean | No | - | | -a[ll] | | -rc, -n, -N |
Use flag-h flag
ip inetDisplay help message
ip --helpDisplay the current IP addresses and network interfaces
ip addr showDisplay the routing table
ip route showAdd a new IP address to an interface
ip addr add 192.168.1.100/24 dev eth0Delete an IP address from an interface
ip addr del 192.168.1.100/24 dev eth0Bring an interface up
ip link set dev eth0 upBring an interface down
ip link set dev eth0 downShow network interfaces and link status
ip link showAdd a new default gateway
ip route add default via 192.168.1.1Delete the default gateway
ip route del defaultFlush all IP addresses on an interface
ip addr flush dev eth0Change the MAC address of an interface
ip link set dev eth0 address 00:11:22:33:44:55Show information about tunnels
ip tunnel showShortcut: Show brief information about IP addresses and devices
ip -brief addr showShortcut: Show brief information about link status
ip -brief link showip is a command-line utility for show/manipulate routing, devices, policy routing and tunnels.
ip -h {flag-h}